Barcode Parameters
Last updated: 04-Dec-2024
This table describes the required parameters used for Barcode.
| Config.usr1/Parameter DLD Name | Description | Valid/Max Values | Default Value | Name in PropertiesData.xml |
|---|---|---|---|---|
| TRIGMODE | This parameter is used to set the Trigger mode, using the given values. |
|
1 | TRIGMODE |
| AUTOBEEP | This parameter is used to set beep behaviour of the scanner. It controls whether the beep occurs after a valid scan, only an error, both scenarios, or not at all. |
|
0 | AUTOBEEP |
| PICKLIST | This parameter is used to enable or disable the picklist mode. Picklist mode is where the barcode reader decodes only barcodes that are aligned under the center of the aiming pattern. |
|
0 | PICKLIST |
| SESTIMEOUT |
|
Numeric | 10000 milliseconds | SESTIMEOUT |
| SAMSYMTO | This parameter is used to set the time in milliseconds for same symbol scan timeout. Timeout range is 1000 - 255000 milliseconds. In Continuous mode, the maximum allowed timeout is 255000 milliseconds. In Single Scan Mode, the maximum allowed timeout value is 10000 milliseconds. | Numeric | 0.6 seconds | SAMSYMTO |
| DIFSYMTO | This parameter is used to set the time in milliseconds for different symbol scan timeout. While Continuous mode is enabled, this method needs to be used to prevent multiple reads of a symbol left in the decoder’s field of view. The timeout begins when a symbol is removed from the field of view. | Numeric | 0.2 seconds | DIFSYMTO |
| CONMODE | This parameter is used to enable or disable the continuous mode. Continuous mode is where the barcode laser scans continuously. Normally, the laser shuts off and the scanning session ends after one successful scan/decode. Continuous mode is enabled with any of the Trigger modes. |
|
0 | CONMODE |
| PHONDISMODE | This parameter is used to enable or disable the phone and electronic display mode. This setting improves barcode reading performance with target barcodes displayed on mobile phones and electronic displays. |
|
0 | PHONDISMODE |
| DATATRNSMODE | Changes the scan data format to have a custom prefix and/or suffix1 and/or suffix2 value. |
|
0 | DATATRNSMODE |
| AIMPATTERN | This parameter is used to enable or disable the AIM pattern. When enabled, the dot pattern for the laser is used during barcode capture. |
|
1 | AIMPATTERN |
| UNIREPORT | This parameter is used to enable or disable the report unique barcodes. While continuous mode is enabled, this setting to be used for only report unique barcodes during the scanning session. |
|
0 | UNIREPORT |
| ASYNCPOSSCAN | This parameter is used to enable or disable the multi scan. |
|
0 | ASYNCPOSSCAN |
| DATAPRF | Value of scan data prefix. This is used when scan data transmission format prefix + data is selected to set the prefix value. | 13 | DATAPRF | |
| DATASUFX1 | Value of scan data suffix 1. This is used when scan data transmission format data + suffix1 is selected to set the suffix1 value. | 13 | DATASUFX1 | |
| DATASUFX2 | Value of scan data suffix 2. This is used when scan data transmission format data + suffix2 is selected to set the suffix1 value. | 13 | DATASUFX2 | |
| BCRESTOREDEFAULT | This parameter is used to restore the default barcode configuration. | 0 | BCRESTOREDEFAULT | |
| SETSYMBOLOGY | This parameter is used to set symbology option. | 0 | SETSYMBOLOGY | |
| DISPLAYSCANNINGUI | This parameter is used to display the UI while scanning barcode on e280. |
|
0 | DISPLAYSCANNINGUI |
Rate this article:
